Forward-Facing Installation; Lap-Shoulder Belt Installation (Preferred Method) - Britax ADVOCATE Guia Del Usuario

Britax Child Safety, Inc.

Forward-Facing Installation

IMPORTANT:
facing position.

Lap-Shoulder Belt Installation (Preferred Method)

1. Remove the tether
from the tether storage
compartment and retainer
tabs and place it up and
over the child seat back.
2. Place upright forward-
facing on the vehicle seat.
NOTE: Ensure that the
base of the child seat is
flat on the vehicle seat
and no more than 3 in.
(7.5 cm) of the base
hangs over the edge
of the vehicle seat (see
page 27).
3. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
4. Slide both the lap and
shoulder parts of the
vehicle belt into the
forward-facing belt slots.
5. Buckle the seat belt.
NOTE: Ensure the vehicle
belt is not twisted and
buckle the seat belt.
6. Remove slack from the
lap part (A), then the
shoulder part (B) of the
vehicle belt.
14
Do not use the anti-rebound bar in a forward-
Table of Contents
3"
3a
3b
6a
6b