To remove the jumper cables
Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Tire pressure
We recommend a tire pressure of 100 kPa (1.0 bar /
14.5 PSI) on all 4 tires.
To replace the drive belt for the cutting
deck
1. Lower the cutting deck.
2. Remove the front cover.
3. Pull the spring handle to the left out from the spring
holder to loosen the tension on the tension wheel for
the drive belt.
4. Remove the left side cover on the cutting deck.
242 - 003 -
5. Pull the spring stay from the lift chain.
6. Remove the 4 screws and remove the belt guard.
7. Remove the belt from the pulley, lift the belt holder
(A) and remove the belt from the tension wheel.
8. Remove the belt from the pulley on the tool frame.
A
29