To Assemble The Cutting Head; To Assemble The Bar And Chain; Assembly; To Assemble The Shaft - Husqvarna MADSAW 525iDEPS Manual De Usuario

To assemble the cutting head

CAUTION:
drive shaft inside the shaft engages
with the cut-out in the cutting head.
B
1. Loosen the screw on the cutting head. (A)
2. Fit the cutting head on the shaft so that the
screw (A) is aligned with the hole in the
shaft as shown.
3. Finger tighten the screw (A). Make sure
that screw (A) fits into the hole in the shaft.
4. Tighten screw (A).
5. Tighten screw (B).

To assemble the bar and chain

1. Unscrew the bar nut and remove the
protective cover.
2. Fit the bar over the bar bolt. Place the bar
in its rearmost position. Place the chain
over the drive sprocket and in the groove
on the bar. Begin on the top side of the
bar.
3. Make sure that the edges of the cutting
links are facing forward on the top edge of
the guide bar.
14

Assembly

Make sure that the
A
4. Fit the cover and locate the chain adjuster
pin (A) in the hole in the bar. Check that
the drive links of the chain fit correctly on
the drive sprocket (B) and that the chain
is in the groove in the bar (C). Tighten the
bar nut finger-tight.
A
5. Tension the chain by turning the chain
tensioning screw clockwise using the
combination spanner. The chain should be
tensioned until it does not sag from the
underside of the bar.
6. The chain is correctly tensioned when it
does not sag from the underside of the bar,
but can still be turned easily by hand. Hold
up the bar tip and tighten the bar nuts with
the combination spanner.
7. When fitting a new chain, the chain tension
has to be checked frequently until the
chain is run-in. Check the chain tension
regularly. A correctly tensioned chain
ensures good cutting performance and
long life.

To assemble the shaft

1. Select the applicable shaft for your
operation.
B
1744 - 008 -