Flex MS 1706 FR Instrucciones De Funcionamiento página 10

Instruction manual
1. Pull out the mains plug.
2. Lift the lock (5.) for the guard hood
and rotate by 180°.
3. Remove the guard hood (3.).
4. Press the spindle lock (12.) and
loosen the quick-release clamping
nut.
DANGER
Risk of injury and damage.
The direction of rotation indicated on
the cutting disc must agree with the
direction-of-rotation arrow on the
gearbox (13).
10
NOTE
The rough side of the quick-release
clamping nut always faces the cutting
disc or distance washer.
5. Remove the cutting discs (b),
clamping flange (d) and distance
washers (c).
To change the cutting discs:
1. Attach new cutting discs (b),
distance washers (c) and clamping
flange (d) in reverse sequence.
2. Screw on the quick-release
clamping nut (a). Depress the
spindle lock (12.) and manually
tighten the quick-release clamping
nut (a).
To change the groove width:
The groove width can be set by
rearranging the distance washers.
NOTE
The minimum groove width is 10 mm.
In all distance washers (c) are fitted in
front of the quick-release clamping nut
(a).
MS 1706 FR