Gear Housing; Warranty - Flex MS 1706 FR Instrucciones De Funcionamiento

Instruction manual
is dependent on the material and
duration of use.
Regularly blow out the housing interior
and motor with dry compressed air.
CAUTION
Wear safety glasses while using
compressed air.
All plastic parts should be cleaned with
soft damp cloth. NEVER use solvents
to clean plastic parts. They could
possibly dissolve or otherwise damage
the material.

Gear housing

The gear housing should never be
loosened or opened, except by a FLEX
authorized service center. Doing so will
void the product warranty.
Brush inspection and lubrication
For your continued safety and electrical
protection, brush inspection and
replacement on this tool should ONLY
be performed by an authorized service
center for FLEX Power Tools.
At approximately 100 hours of use, take
or send your tool to your nearest
authorized service center for FLEX
Power Tools to be thoroughly cleaned
and inspected; worn parts replaced;
and when necessary, relubricated with
fresh lubricant if required; reassembled
with new brushes; and performance
tested.
Any loss of power before the above
maintenance check may indicate the
need for immediate servicing of your
tool. DO NOT CONTINUE TO
OPERATE TOOL UNDER THIS
CONDITION. lf proper operating
voltage is present, return your tool to a
FLEX authorized service center for
immediate service.
14
Repairs
All quality tools will eventually require
servicing or replacement of parts due to
wear from normal use. These
operations, including brush inspection
and replacement, should ONLY be
performed by an authorized service
center for FLEX Power Tools.
All repairs made by these agencies are
fully guaranteed against defective
material and workmanship. We cannot
guarantee repairs made or attempted
by anyone other than these agencies.
Should you have any questions about
your tool, feel free to write us at any
time. In any communications, please
give all information shown on the
nameplate of your tool (model number,
type, serial number, etc.).

Warranty

FLEX North America limited one
year Warranty
FLEX North America warrants its
Professional Power Tools for a period
of one year from the date of original
purchase. We will repair or replace at
our option, any part or parts of the
product and accessories covered under
this warranty, which, after examination,
prove(s) to be defective in
workmanship or material during the
warranty period. For repair or
replacement, return the complete tool
or accessory, transportation prepaid, to
your nearest Authorized Service
Station. Proof of purchase may be
required. This warranty does not apply
to repair or replacement due to misuse,
abuse, normal wear and tear or repairs
attempted or made by someone other
than our Authorized Service Stations.
MS 1706 FR