Flex MS 1706 FR Instrucciones De Funcionamiento página 4

Instruction manual
GENERAL POWER TOOL SAFETY WARNINGS
Failure to follow all instructions listed below, may result in electric
shock, fire and/or serious personal injury.
1. Work area
(a) Keep work area clean and well lit.
Cluttered and dark areas invite
accidents.
(b) Do not operate power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases or
dust. Power tools create sparks which
may ignite the dust or fumes.
(c) Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.
2. Electrical safety
(a) Power tool plugs must match the
outlet. Never modify the plug in any way.
Do not use any adapter plugs with
earthed (grounded) power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
(b) Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric
shock if your body is earthed or
grounded.
(c) Do not expose power tools to rain or
wet conditions. Water entering a power
tool will increase the risk of electric
shock.
(d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
4
Read and understand all instructions.
SAVE THESE INSTRUCTIONS.
WARNING:
(e) When operating a power tool
outdoors, use an extension cord suitable
for outdoor use. Use of a cord suitable
for outdoor use reduces the risk of
electric shock.
3. Personal safety
(a) Stay alert, watch what you are doing
and use common sense when operating
a power tool. Do not use a power tool
while you are tired or under the influence
of drugs, alcohol or medication.
A moment of inattention while operating
power tools may result in serious
personal injury.
(b) Use safety equipment. Always wear
eye protection. Safety equipment such
as dust mask, non-skid safety shoes,
hard hat, or hearing protection used
for appropriate conditions will reduce
personal injuries.
(c) Avoid accidental starting. Ensure
the switch is in the off position before
plugging in. Carrying power tools with
your finger on the switch or plugging in
power tools that have the switch on
invites accidents.
(d) Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to
a rotating part of the power tool may
result in personal injury.
(e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
MS 1706 FR