Adjusting The Cutting Depth - Flex MS 1706 FR Instrucciones De Funcionamiento

MS 1706 FR
1. Attach the cutting disc (b), distance
washers (c) according to the
required groove width and clamping
flange (d).
2. Attach the remaining distance
washers (c).
3. Screw on the quick-release
clamping nut. Depress the spindle
lock (12.) and manually tighten the
quick-release clamping nut (a).
4. Gently depress the milling unit and
attach the guard hood (3.).
5. Lift lock (5.) for guard hood and
rotate by 180° until it engages.
6. Insert the mains plug into the
socket.
7. Switch on the wall chaser (without
locking the switch) and leave
running for approx. 30 seconds.
Check for quiet running.

Adjusting the cutting depth

1. Pull out the mains plug.
2. Depress the lock on the milling depth
stop (2b) and set the stop to the
required depth. Lock the milling
depth stop (2b) at the required
depth.
Using a dust extraction system
CAUTION
When using the wall chaser, connect
a Class M dust extractor.
If a dust bag is used which is not
authorised for use with dry construction
dust, the amount of dust particles in the
air may increase at the work place.
Over a prolonged period high concen-
trations of dust in the air may damage
the human respiratory system.
Insert the special dust bag for dry con-
struction dust into your dust extractor
according to the instructions supplied
with the dust extractor.
Connect extraction hose to the dust
Instruction manual
11