Fitting Instructions - Blatchford AqualimbTF Instrucciones De Uso

8 Fitting Instructions

The instructions in this section are for practitioner use only.
1
Fit shin to housing ensuring full engagement.
Measure length to determine amount to be cut
from shin.
4
1
4
Tighten clamp screws evenly, applying a torque
of 5 Nm at least twice to each screw. Example
order of tightening shown to evenly spread load.
3
2
2
45 mm
Determine final cut length required.
3
Remove shin from housing, cut to length and
reassemble then check measurement.
5
Check length and
alignment. Finalise
the screw settings
during dynamic
alignment.
10
938321PK1/2-0921