Fitting Advice - Blatchford SBTTLP22L Guia Del Usuario

9 Fitting Advice

9.1 Moisture in the distal end of the device
If moisture collects inside the distal end of the device, refer to the following table:
The perforations are clogged.
The lock is stopping the valve from opening.
If moisture continues to collect inside the device, contact your practitioner.
9.2 Loss of vacuum
If the device loses vacuum, refer to the following table:
The valve is damaged.
The locking pin is not aligned with the long
axis of the residual limb.
If the device continues to lose vacuum, contact your practitioner.
12.3 Separation of the valve from the distal cap
If the valve falls of the distal cap, refer to the following table:
The valve is not fitted correctly.
Cause
Cause
Cause
Clean the device. (See section 5.1.)
Put the spacer between the lock and the
valve. (See section 7.)
Stop using the device, and contact your
practitioner.
Re-align the locking pin
the residual limb.
Make sure that the washer is between the pin
and the valve. (See section 6.)
7
Solution
Solution
with the long axis of
Solution
938399/2-0719