Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 7 - Remove the Navigation Radio
Procedure
1. Remove the screws retaining the radio to the I/P center support
bracket.
2. Remove the radio control from the center support bracket enough
to access the connectors at the rear of the radio head unit.
3. Disconnect the electrical/audio and coaxial cable connectors from
the radio control.
4. Remove the Navigation Radio. Figure 9.
FIGURE 9
STEP 8 - Install and Route T-Harness into Navigation
Radio I/P Harness
1. Install T-Harness between vehicle harness and radio as shown in
Figure 10.
2. Reconnect XM, AM/FM and GPS antenna wires to the back of
the radio.
FIGURE 10
Personal Audio Link (PAL)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
Procedure
2. Unwrap the single class 2 wire and begin routing point at lower left
side of the center console heating duct. Route wire down towards
the floor of the vehicle. Figure 11.
FIGURE 11
3. Pull all excess wire down towards floor in preparation to route wire
behind driver knee bolster. Figure 12.
FIGURE 12
PART NO.
IR23JN08
INSTALLATION INSTRUCTIONS
DR
TITLE
Personal Audio Link (PAL)
PART NO.
19201501
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19201501
SHEET
3
SHEET
3
21
OF
21
OF
Publicidad
