Publicidad
Idiomas disponibles
Idiomas disponibles
2. Re-install glove box. Figure 30.
FIGURE 30
STEP 11 - Module Mounting Preparation
1. Clean mounting area with adhesion promoter. Figure 31.
FIGURE 31
2. Plug both connectors into PAL module. Figure 32.
FIGURE 32
Personal Audio Link (PAL)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
3. Remove adhesive strip from bottom of PAL module and
position module as shown with iPod cable facing forward in
vehicle and the 16-pin connector facing the rear of vehicle.
Make sure that module or harness does not protrude past
plastic bracket so that the floor carpet will seat correctly.
Figure 33.
FIGURE 33
STEP 12 - Re-install Vehicle Components
Front Floor Kick-Up Panel
HVAC Unit
Navigation Radio
Trim Plate
Parking Brake Lever Boot
Center Trim Panel
Passenger Side Center Trim Carpet
Close Out Panel
Connect Negative Battery Terminal
Accessory Trim Plate
STEP 13 - Final Quick Device Check
1. If no iPod is connected you will see "No iPod" when you
press the XM2 band soft key.
2. If an iPod is available, then after connecting the iPod and
having the ignition on, press the XM2 band soft key and then
the iPod User Interface Screen should appear.
PART NO.
IR23JN08
INSTALLATION INSTRUCTIONS
DR
TITLE
Personal Audio Link (PAL)
PART NO.
19201501
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19201501
SHEET
7
SHEET
7
21
OF
21
OF
Publicidad
