Publicidad
Idiomas disponibles
Idiomas disponibles
Lower the I/P Lower Closeout Panel
4. Locate the I/P harness behind the driver knee bolster panel and
route single Class 2 wire along side the IP harness. Install tie
straps as shown. Figure 13 and Figure 14.
FIGURE 13
Continue routing wire to driver side terminal-splice pack.
FIGURE 14
NOTE! PIN-K MUST BE COMPLETELY REMOVED.
NO WIRES GO BACK INTO PIN-K CAVITY.
5. Remove Pin-K from the terminal-splice pack connector and cut
the terminal off and expose the bare wire to prepare for the
crimping operation. After Pin-K is removed, the splice pack comb
and tape may be re-installed. Figure 15, Figure 16, Figure 17 and
Figure 18.
FIGURE 15
Personal Audio Link (PAL)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Tie Straps
REVISION
FIGURE 16
6. Take the single PAL harness wire that was pulled through the I/P
and Crimp to the wire that was removed from Pin-K.
FIGURE 17
Sealed Splice Instructions:
A. Position stripped ends of wire into sleeve until wire hits
stops.
B. Hand crimp each side of the sleeve seperately using the
approved crimping tool (GM part number 12085115).
Gently tug on the wires to make sure they are securely
crimped.
C. Apply heat carefully to shrink the tubing. Use a heat
gun or GM Ultra Torch (GM part number 12085116).
D. Check for electrical continuity.
PART NO.
IR23JN08
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
Personal Audio Link (PAL)
PART NO.
19201501
6200 Grand Pointe Dr., Grand Blanc, MI 48439
Wire Stop
Crimp
Apply Heat
Evidence of Glue
19201501
SHEET
4
SHEET
4
21
OF
21
OF
Publicidad
