Publicidad
Idiomas disponibles
Idiomas disponibles
3. Pull iPod connector through and seat grommet into hole.
Figure 24.
FIGURE 24
4. Route iPod connector through rectangular opening inside
glove box cavity on I/P. Figure 25 and Figure 26.
FIGURE 25
FIGURE 26
Personal Audio Link (PAL)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
5. Route iPod connector through opening where lower corner of
center console meets lower left side of glove box area and
route iPod connector down the side of center console and
tuck under the foam block. Figure 27.
FIGURE 27
6. Continue routing behind plastic panel and leave enough
excess wire to attach module in a later step. Figure 28.
FIGURE 28
STEP 10 - Install Glove Box
Procedure
1. Pull excess iPod connector through and leave enough slack
to allow for opening and closing of glove box. Figure 29.
FIGURE 29
PART NO.
IR23JN08
INSTALLATION INSTRUCTIONS
DR
TITLE
Personal Audio Link (PAL)
PART NO.
19201501
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19201501
SHEET
6
SHEET
6
21
OF
21
OF
Publicidad
