Publicidad
Idiomas disponibles
Idiomas disponibles
Carefully align middle pole section (5) into top pole section (4) as shown. Bounce sections
2.
together using a wood scrap, while maintaining alignment, until the top pole section (4) reaches
the mark line on middle pole section (5).
You should have a 4.0" (10.2 cm) overlap when properly assembled.
NOTE: IF MINIMUM POLE ENGAGEMENT WHICH ALLOWS THE HARDWARE TO BE ASSEMBLED CANNOT BE ACHIEVED
!! STOP !!
DO NOT PROCEED TO THE NEXT STEP! - CALL SPALDING CUSTOMER SERVICE FOR ASSISTANCE.
TWO CAPABLE ADULTS REQUIRED FOR THIS PROCEDURE.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN
SERIOUS INJURY AND/OR PROPERTY DAMAGE.
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 4.0" (10.2 CM)
OVERLAP.
IMPORTANT!
Align the top pole section (4) into the middle
pole section (5) as shown.
5
MIDDLE POLE
MARKED LINE
4
TOP POLE
WARNING!
CAUTION!
MIDDLE POLE
MARK LINE
4.0"
(10.2 cm)
TOP POLE
Wood Scrap
(not supplied)
11
5
(FRONT OF
POLE)
(FRONT OF
POLE)
4
Publicidad
