Publicidad
Step 7
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the LEFT END (B) and LEFT UPRIGHT (F). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten the L-LOCK BRACKET (76G) to the LEFT UPRIGHT (F). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
Open end
www.sauder.com/service
3S
Groove
B
3
2
1
F
4
426914
7
40MA
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
76G
1
2
3
4
1S
Open end
Page 13
Publicidad
