Publicidad
Step 32
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the DOOR (V) to the RIGHT END (A) as shown in
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
å
Fasten a PULL (189K) to the DOOR (V). Use two BLACK
9/16" LARGE HEAD SCREWS (1S).
å
See the next step for DOOR adjustments.
Page 38
Stop
Mounting
screw
Adjusting
screw
Hinge
426914
17
BLACK 9/16" LARGE HEAD SCREW
(2 used for the PULL)
189K
A
V
www.sauder.com/service
1S
Publicidad
