Publicidad
Step 38
1
D87
W
Groove
å
Insert the LARGE DRAWER SIDES (D88 and D87) at an
angle into the slot at each end of the LOCKING
DRAWER FRONT (W).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the LARGE DRAWER BACK (D78) to the DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D78).
Page 44
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D708) into the grooves in
the LARGE DRAWER SIDES (D87 and D88) and LOCKING
DRAWER FRONT (W).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
426914
With the palm of
your hand, tap
the DRAWER
BOTTOM down
U n fi
into the groove.
n i s h
s u r
e d
f a c
e
D708
D87
D88
W
30S
(4 used in this step)
www.sauder.com/service
9
Publicidad
