Publicidad
Step 36
1
D130
Groove
å
Insert the SMALL DRAWER SIDES (D130 and D136) at an
angle into the slot at each end of the DRAWER FRONT (U).
3
BLACK 9/16" LARGE HEAD SCREW
(2 used for the BRACKET)
77G
å
Fasten the DRAWER BACK (D109) to the SMALL DRAWER SIDES (D130 and D136). Use four BLACK 1-9/16" FLAT HEAD
SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D109).
å
Fasten the Z-LOCK BRACKET (77G) to one of the SMALL DRAWER FRONTS (U) exactly as shown. Use two BLACK 9/16"
LARGE HEAD SCREWS (1S).
å
Repeat this step for the other small drawer without the Z-LOCK BRACKET (77G).
Page 42
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D136
U
1S
D130
2
D130
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D708) into the grooves
in the SMALL DRAWER SIDES (D130 and D136) and
DRAWER FRONT (U).
D109
D708
D136
426914
With the palm of
your hand, tap
the DRAWER
BOTTOM down
U n fi
into the groove.
n i s h
s u r
e d
f a c
e
D708
D136
U
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
www.sauder.com/service
9
Publicidad
