ENGLISH
Push the battery up.
Once the battery is held up, pull it out horizontally.
How to assemble the battery
Fig. 38.
Insert the battery horizontally into the poles.
Push it down until the lock latch on the battery case is fixed into place.
Use of the tyres
For a correct operation of the scooter, always check and maintain the correct pressure of your
tubeless tires.
The optimum tyre pressure is 50 PSI / 3.4 bar / 340 kPa.
If you are using the scooter for the first time, make sure the pressure is correct. We recommend
checking the pressure regularly to ensure that the pressure is on the recommended values for
efficient driving.
We recommend the use of a heat-sealed gel on the tyres to prevent punctures and maintaining
its effectiveness and features.
5. CLEANING AND MAINTENANCE
Make sure the robot is disconnected from the power plug and switched off before cleaning or
repairing it.
Use a soft cloth to clean the outside part of the scooter.
Do not immerse the scooter in water or other liquids to clean it. This could cause permanent
damage to its electronic parts.
Do not try to repair the appliance by yourself. If it presents any damage or fault, contact the
Technical Support Service of Cecotec.
Storage
Make sure the scooter is charged before being stored for long periods of time. Charge it at least
once a month.
Only charge it at a room temperature between 0 ºC and 35 ºC and store it between - 10 ºC and
35 ºC.
Store the scooter indoors, in a dry and safe place. Cover it or wrap it to protect it from dust if
necessary.
45
BONGO SERIE A ADVANCE MAX CONNECTED