Cebora 392 Manual De Instrucciones página 28

3�8 Description of functions shown on the display screen A
the welding process "SHORT or PULSED", the welding current, the speed of the welding wire in metres/min, the
welding voltage and the recommended thickness.
To increase or decrease the welding parameters, simply adjust by means of knob B. The values all change together
in a synergic way.
To change the welding voltage V, simply press the knob B for less than 2 seconds. The display screen will show (Arc
Length) an adjustment bar with central 0. The value can be changed by means of the knob B from -9.9 to 9.9. To exit
from the function, briefly press the knob B.
By changing the value, once having exited the sub-menu, alongside the voltage V, an arrow will appear turned upwards
to indicate a higher adjustment of the set value, while the arrow turned downwards will indicate a lower adjustment.
Service functions (PROCESS PARAMS) shown on the display screen A
3�9
The software could have been updated, therefore the device in use may offer functions not
described in these user instructions, or the opposite may apply� Individual figures may also
deviate slightly from the control elements present on the device in use. The operation of these control
elements is nevertheless identical.
To access these functions, we must start from the main screen and press the knob B for at least 2 seconds.
To enter the function, simply select it by means of the knob B and press it for less than 2 seconds. To return to the
main screen, press the knob B for at least 2 seconds.
The functions which can be selected are:
• Synergic curve (Wire Selection).
To choose the synergic curve, by means of the knob B, it is necessary to select and press on the curve presented
by the display screen A. Simply select the curve of interest and confirm the choice by pressing the knob B for less
than 2 seconds.
28/37
When the machine is switched on, for a few moments the display screen A shows: the item
number of the machine, the version and development date of the software, and the release
number of the synergic curves (this information is also provided in section 7.1 SERVICE
FUNCTIONS).
Immediately after switch-on, the display screen A shows:
The synergic curve used, the welding mode 2T, 4T or 3L, the SPOT function, if enabled,
NOTICE
3301278