Cebora 392 Manual De Instrucciones página 29

After pressing the knob B return is made to the previous screen (PROCESS PARAMS).
• Process
Use knob B to choose or confirm a welding mode by selecting and pressing Short or Pulsed for at least 2 seconds.
Short indicates that the short synergic welding mode is selected.
Pulsed indicates that the pulsed synergic welding mode is selected�
• Welding mode (Start Mode).
To choose the welding start mode 2T, 4T or 3L, select one of the 2 modes by means of the knob B and press the
knob B for less than 2 seconds to confirm the choice. This operation always returns us to the previous screen
(PROCESS PARAMS).
Mode 2T, the machine starts welding when the torch trigger is pressed and stops when this is released.
Mode 4T, to start welding, press and release the torch trigger. To complete welding, press and release again.
Mode 3L Particularly recommended for welding aluminium.
Three welding currents can be selected using the torch trigger. The current and the slope time values are set as
follows:
Start Curr Starting current, adjustable from 10 to 200% of set welding current.
Slope time Adjustable from 0.1 to 10 seconds. Defines the connection time between starting current (Start Curr)
and welding current and between welding current and crater filler current or crater filling when welding is complete
(Crater Curr).Adjustable from 10 to 200% of set welding current.
Welding starts at the torch trigger pressure. The current called up will be the starting current Start Curr. This cur-
rent is maintained as long as the welding torch trigger is held down; when the torch trigger is released the starting
current connects to the welding current, which is kept as long as the torch trigger is pressed again. When the torch
trigger is pressed again, the welding current will connect to the crater-filler current (Crater-Curr) and it will be
maintained until the torch trigger is released.
3301278
29/37