Sony Handycam Video8 CCD-TR403 Manual De Instrucciones página 47

AC Power Adaptor
Symptom
The POWER lamp does not
light.
The CHARGE lamp flashes.
When the CHARGE Lamp Flashes
Check through the following chart.
Remove the battery pack from the
AC power adaptor. Then install the
same battery pack again.
When the CHARGE lamp
flashes again
Install another battery pack.
When the CHARGE lamp
flashes again
The problem is with the AC power
adaptor.
Please contact your nearest Sony
dealer in connection with the
product with the problem.
∗ If you use a battery pack which you have just bought or which has been left unused for a long time,
the CHARGE lamp may flash at the first charging. This does not indicate a problem. Repeat again to
charge with the same battery pack.
Cause and/or Corrective Actions
m Set the selector to VTR (DC OUT) and disconnect the AC
power cord. After about one minute, try again.
• See the following chart.
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, there is no
problem.*
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, the problem is
with the battery pack installed first.
47
CCD-TR403_3-858-957-12.E/S