Husqvarna RC 318T Manual De Usuario página 14

12. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
13. Pull the auger servicing position lever to up position.
14. Attach the front cover.
To remove the cutting deck
To attach the cutting deck on page
1. Do steps 1–5 in
13 .
2. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
3. Pull the spring handle to the right out from the spring
holder to loosen the tension on the tension wheel for
the drive belt. (1)
4. Hold the spring handle with your left hand and lift off
the drive belt with your right hand.
5. Pull the drive belt to the rear below the product. Do
not put it in the belt holder (2).
6. Put the spring handle in the spring holder to prevent
that the spring falls down.
14
7. Lift the cutting height stay and put it in the holder for
the cutting height stay (3).
8. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
9. Lift the service lock to vertical position.
WARNING:
mechanism can cause injury to
fingers if you do not operate it
carefully. Put the service lock in full
vertical position and hold the front
edge of the cutting deck with two
hands when you continue to the
next step.
10. Lift the front edge of the cutting deck until the service
lock touches the frame and pull the cutting deck out.
3
2
1
The lock
368 - 006 - 10.11.2022