Husqvarna RC 318T Manual De Usuario página 27

To set the tire pressure
The correct tire pressure is 150 kPa (1.5 bar / 21.8 PSI)
on all 4 tires.
To put the cutting deck in servicing
position
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
4. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck.
5. Lower the auger control lever to lift the auger to
servicing position.
368 - 006 - 10.11.2022
6. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
7. Pull the spring handle (1) to the right out from the
spring holder to loosen the drive belt tension.
8. Hold the spring handle with your left hand and lift off
the drive belt with your right hand.
9. Put the drive belt in the belt holder (2).
10. Put the spring handle in the spring holder to prevent
that the spring falls down.
11. Lift the cutting height stay and put it in the stay
holder. (3)
12. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
13. Lift the cutting deck to vertical position until a
click sound is heard. The cutting deck is locked
automatically in the vertical position.
3
2
1
27