Husqvarna RC 318T Manual De Usuario página 24

To remove and install the right side cover
Remove the 4 screws and lift off the cover.
Right footrest plate
Turn the knob on the reverse pedal to remove it.
Remove the 4 screws and remove the footrest plate.
Left footrest plate
Remove the 4 screws and remove the footrest plate.
24
To replace a broken lamp
1. Remove the 2 screws on the cover and lift it off.
2. Disconnect the cables from the broken lamp.
3. Replace the lamp and connect the cables to the new
lamp. Use the type of lamp as given in
data on page 36 .
4. Attach the cover and tighten the screws.
To examine the steering wires
The tension of the steering wires can decrease after
a period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a hard surface that slopes
maximum 10°.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Press the parking brake pedal down (1).
Technical
368 - 006 - 10.11.2022