Husqvarna RC 318T Manual De Usuario página 30

4. Turn the lift strut to extend the stay or make it
shorter. Extend the stay to lift the rear edge of the
cover. Make the stay shorter to lower the rear edge
of the cover.
5. Tighten the nuts on the lift strut when the adjustment
is done.
6. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
29 .
7. Attach the belt shield and tighten the screws.
8. Attach the right footrest plate and the front cover.
To examine the blades
Put the cutting deck in servicing position. Look at the
blades to see if they are damaged and if it is necessary
to sharpen them. Tighten the blade bolts with tightening
torque 60 Nm, in the direction of the arrows in the
illustration.
CAUTION:
balanced blades cause unbalance that can
damage the product. Replace damaged
blades. Let an authorized service agent help
you sharpen and balance blunt blades.
To replace the blades
CAUTION:
damaged if you try to loosen them in the
incorrect direction.
1. Put the cutting deck in servicing position.
30
To do a
Damaged or incorrectly
The bolt heads can be
2. Lock the blade with a wooden block.
3. Loosen and remove the blade bolt, the washers and
the blade. Loosen the blade bolts in the direction of
the arrows in the illustration.
4. Assemble the new blade with the angled ends in the
direction of the cutting deck.
WARNING:
type can cause objects to eject from
the cutting deck and cause serious
injury. Use only the blades given in
Technical data on page 36 .
5. Attach the blade with the washer and the bolt with
tightening torque 60 Nm.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
Incorrect blade
368 - 006 - 10.11.2022