Husqvarna RC 318T Manual De Usuario página 28

14.
To put the cutting deck in mow position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
CAUTION:
caught below the cutting deck. Pull on
the drive belt loop in the belt holder
before you push the cutting deck in.
4. Lift the cutting height stay from the stay holder and
put it in the hole (1).
5. Hold the spring handle and lift the drive belt out of
the holder.
28
The drive belt can get
1
2
3
6. Put the drive belt around the tension wheel (2). Make
sure the drive belt runs as shown in the illustration.
7. Put the spring in the spring holder (3).
8. Pull the auger servicing position lever up into
operation position.
9. Attach the front cover.
10. Set the cutting height lever in one of the positions
1–8.
To do a check of and adjust the cutting
deck ground pressure
To get the best mowing results it is important to have
correct pressure from the cutting deck on the underlying
surface.
1. Make sure that the air pressure in the tires is 150
kPa (1.5 bar / 21.8 PSI).
2. Park the product on a level surface.
3. Lower the cutting deck to mowing position.
368 - 006 - 10.11.2022