Husqvarna RC 318T Manual De Usuario página 20

Maintenance
Do a check of and clean hydraulic hoses and couplings. Replace if necessary.
Do a check of the belts and pulleys.
Do a check of the steering chain of the inner side of the frame tunnel.
Do an inspection, lubricate and adjust all wires.
Make sure that the tire pressure is correct. Refer to
page 27 .
Make sure that all screws and nuts are tightened with the correct torque.
Lubricate the operators seat.
Lubricate all chains.
Lubricate the wheels and blade bearings on the cutting deck (if applicable).
Lubricate the pedals on the inner side of the frame tunnel.
Lubricate the belt tensioners
Remove the drive wheels and lubricate the axels (for 200-300 series only)
Do a check of the fuel hose. Replace if it is necessary.
Replace the fuel filter. Refer to
Clean the air filter. Refer to
Replace the air filter. Refer to
Do an inspection of the cooling fins on the hydrostatic transmission.
Clean the engine and the hydrostatic transmission.
Do a check of the muffler and the heat deflector.
Replace the engine oil. Refer to
page 31 .
Replace the engine oil filter
31 .
Replace the spark plug. Refer to
25 .
Do a check on the lights (if applicable). Refer to
page 24 .
Update the firmware (if applicable).
Do a check of the battery and charge if it is necessary. Refer to
battery on page 26 .
1
2
3
4
20
To replace the fuel filter on page 25 .
To clean and change the air filter on page 25 .
To clean and change the air filter on page 25 .
To change the engine oil and the oil filter on
To change the engine oil and the oil filter on page
To examine and replace a spark plug on page
To replace a broken lamp on
50 hours or one year (first service only).
100 hours or one time each year.
50 hours or one year (first service only).
100 hours or one time each year.
To set the tire pressure on
To charge the
First Maintenance interval
servicing in hours
50 100
O
O O
O
O
X X
O
O
O
O O
O
O
O
O
X
X
X
O
O
O O
1 2
X X
3 4
X X
X
X X
O O
X X
368 - 006 - 10.11.2022
200