Husqvarna RC 318T Manual De Usuario página 17

5. Turn the key to the lights position to make the
headlights come on.
6. Push the throttle control to full throttle position (A).
To use the product in collect mode
1. Start the engine.
2. Make sure that the symbol on the auger control
button is green. This shows that the product is in
Auger control switch with LED
collect mode. See
indicators on page 5 for information on what to do if
the symbols on the auger control switch lights up or
the auger control button is red.
3. Press the parking brake pedal down and then
release it to release the parking brake.
368 - 006 - 10.11.2022
A
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
5. Release the pedal to brake. On model RC 318T,
you can use the service brake/parking brake pedal to
get more braking power. This can be necessary for
example when you brake on a slope.
6. Select cutting height (1–8) with the cutting height
lever.
7. Press the lock button on the lift lever for the cutting
deck and lower it to mowing position.
8. When the collector is full, a symbol (see
control switch with LED indicators on page 5 ) lights
up in orange on the auger control switch and a beep
is heard.
Note:
The beep that sounds when the
collector is full can be blocked out by the
hearing protection. Look at the auger control
switch regularly to not miss when the collector
is full.
1
2
Auger
17