Heiniger ORION Instrucciones De Manejo Originales página 32

7 Troubleshooting
y The here described tasks for troubleshooting can be done mostly by the operator.
y Some tasks may only be done by especially trained personal or by an authorised service
centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts poorly or
not at all
Motor is not running
Motor runs very
slowly
Running time of a
fully charged battery
is too short and / or
blades are getting
hot
The control light of
the charging station
in not on
When battery is flat
the light does not
change from green
to red
16
Cause
Clipper head is not well
engaged
Turning lever is defective
Clipper blades are blunt
Clipper blades have not
been correctly ground as per
specification
Clipper blades are not oiled
Hairs jammed between top
and bottom blades
Clipper head has too little
clipping pressure
Battery is dead
Contacts dirty
Faulty battery
Smell of burning from the
motor housing. Motor burned
out.
Faulty motor and / or elec-
tronics
Clipper head blocked
Clipper blades were not oiled
sufficiently
Clipper blades were not oiled
sufficiently
Dead, not fully charged or
defective battery has been
used
Charging station is not con-
nected to the power supply
Charging station is faulty
Contacts of battery and/or
charging station are dirty
Faulty battery
Contacts of the charging
station are deformed
Translation of the original instructions / Hair clippers
Rectification
Engage the clipper head correctly
when the motor is running
Replace turning lever (S)
Have top and bottom blades resharp-
enend by service centre (S)
Oil clipper blades every 15 minutes
Take off clipper head, push the top
blade half away from the clipper head,
take away hairs between top and
bottom blade
Have clipper head inspected (S)
Charge battery
Switch the clipper off and clean the
contacts of the clipper and the battery
Replace battery
Have motor and / or electronics re-
placed (S)
Have motor and / or electronics re-
placed (S)
Clean and oil clipper head
Oil clipper blades
Oil clipper blades
Only use intact and completely
charged original battery
Connect the charging station to the
power supply
Have charging station inspected (S)
Clean contacts
Replace battery
Have the charging station repaired (S)