Publicidad
Idiomas disponibles
Idiomas disponibles
LED display
Heater Button
Bubble Button
- Adjust the bubble level by
pressing the button
(L1:300W, L2: 500W, L3:720W)
Ozonator Button
LED display
°C
°F
Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically.
NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as
approximately 1°C.
HEATING
1. Press the
HEATER button to turn the heating system on/off. The HEATER icon shown on the LED display
HEATER
HEATER
means the heating system is activated. The flashing HEATER icon means the spa is at the set temperature and the
heating system is at rest.
UP
DOWN
20-40°C
2. Pressing the
The new and desired temperature setting will remain on the LED display for 3 seconds to confirm the new value.
NOTE: The default temperature is 40°C.
NOTE: If the heating system is turned on, the filtration system will automatically start.
NOTE: When the water temperature is below 1°C (33.8°F), the anti-icing system will be activated automatically to heat
the water to 3°C (37.4°F).
IMPORTANT: The following conditions will lead to slow water heating
●
An ambient temperature lower than 10°C (50°F).
●
An outdoor wind speed above 3.5-5.4m/s (8-12mph).
●
If the air bubble function is activated when the heater is on.
●
If the spa cover is not properly in place when the heater is on.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when
not in use.
Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g.
10ml/l of free Chlorine).
ALL-IN-ONE CONTROL PANEL
UP or
DOWN button to adjust the water to the desired temperature setting (from 20°C to 40°C ).
Down Button
Up Button
Lock
11
Filter Button
Timer Button
UVC Button
Unlock
Publicidad
