Publicidad
Idiomas disponibles
Idiomas disponibles
FILTRATION
Press the
FILTER button to turn the function on/off. The FILTER icon shown on the LED display means the
FILTER
FILTER
function is activated.
NOTE: The filtration system will automatically start when the heating, Ozone or UVC sanitizing system is activated.
NOTE: After turning off the heating system, the filtration system will automatically stop in 30 seconds.
Filter Cartridge Cleaning Reminder: When the FILTER icon flashes continuously, the filter cartridge must be cleaned
or replaced. Once this has been done, press the FILTER button for 3 seconds to reset the reminder.
Auto-filtration: When the spa is in stand-by mode, the filtration system will operate automatically for 60 minutes every
8 hours.
BUBBLE MASSAGE
Press the
BUBBLE button to turn the function on; hold down the BUBBLE button for 3 seconds to turn the
BUBBLE
BUBBLE
function off.
The bubble setting can be adjusted to three different levels. The default setting is at level 2
BUBBLE button to switch the setting to level 3
IMPORTANT: Do not turn on the massage system when the cover is attached. Air can accumulate inside the spa and
cause irreparable damage and bodily harm.
NOTE: The bubbling massage function will shut down automatically after every 20 minutes of operation as a safety
precaution. This can be reactivated after 10 minutes by pressing the BUBBLE button again.
HEATING TIMER
To set the number of hours FROM NOW when the heater will activate:
TIMER
1. Press the
1-99H
TIMER
2. Pressing the
number of hours before heater activation (from 1 to 99 hours). The desired timer setting will remain on the LED
display for 3 seconds to confirm the value.
To modify the timer setting: Press the Timer button again and use the UP or the DOWN button to adjust.
Cancel the setting: Press the TIMER button for 3 seconds.
NOTE: Activating the heating system or rebooting the spa will cancel the timer setting.
UVC SANITIZER
Press the
UVC button to turn the UVC sanitizing system on/off. The UVC icon shown on the LED display means
the UVC sanitizing system is activated.
NOTE: The UVC emitter is built inside the control box. Therefore, the function can be turned on at any time, even with
people inside the spa.
OZONE
OZONE button to turn the function on / off. The Ozone icon shown on the LED display means the
Press the
function is activated. The Ozonator will shut down automatically after operating for 2 hours.
NOTE: For bathers' safety concerns, please do not soak in the spa when the Ozone is on. The Ozone function cannot
be turned on when the BUBBLE function is on. We suggest to turn on the function after using the spa.
SAFETY LOCK
+
Press the
UP and
3s
mode, the controller is disabled and the spa retains all previous settings.
Celsius/Fahrenheit Toggle Button
The temperature can be displayed in either Celsius or Fahrenheit. Press the
between the two options.
3s
TIMER button to enter pre-setting mode. The TIMER icon is shown on the LED display.
UP or
DOWN button will cause the LED to flash. While it is flashing, you can adjust the
DOWN buttons at the same time for 3 seconds to lock/unlock the controller. In safety lock
(720W). Press it again to switch to level 1
12
(500W). Press the
(300W).
DOWN button for 3 seconds to toggle
Publicidad
