mspa TRIBECA F-TR062W Manual Del Propietário página 17

PROBLEM
Power socket failure
PRCD is off
NO DISPLAY ON
THE CONTROL Press the Reset button,
PANEL
the controller is not
PRCD broken
Spa in&outlet connection not
securely tight
Drainage valve is not closed
SPA LEAKING
completely
Water leaks from the spa
pool body
Temperature set too low
Dirty filter cartridge
NOT HEATING The water level is not at the
PROPERLY
minimum water line
Heater failure
The filter pump DOES NOT
WORK
Water has been used for long
period of time
WATER NOT
Insufficient filteration time
CLEAN
Dirty filter cartridge
Improper water maintenance
Auto-off 10 minutes
NO BUBBLE Internal parts damaged
One-way valve broken
Filter cartridge clogged by dirt
FILTER PUMP
or other objects
DOES NOT WORK
Filter system failure
Water level is below the
minimum water line
OZONATOR
Internal parts damaged
FAILURE
Filter pump does not work
CAUSE
Change a socket or repair the socket before use
Reset the PRCD by following the PRCD Testing section
Contact local MSpa Service Center
Contact local MSpa Service Center
Tighten the in&outlet connection
Close the drainage valve. Contact the MSpa Service Center,
if the spa is still leaking
Repair the leaking hole/split with the repair kit material
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact local MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
Change the water
Extend the filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacturer's instructions
Wait for 10 minutes and turn on the Bubble button again
Contact local MSpa Service Center
Contact local MSpa Service Center
Clean or replace the filter cartridge
Contact local MSpa Service Center
Add water above the minimum line
Contact local MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
SOLUTION
17