Publicidad
Idiomas disponibles
Idiomas disponibles
●
Do not bury the electrical cord. Locate the cord where it will not be damaged by lawn
mowers, hedge trimmers or any other equipment.
●
Do not attempt to plug in or unplug the product while standing in water or when your hands are wet.
●
Do not use the spa if it is damaged on delivery and/or if it malfunctions in any way.
●
Contact the MSpa service center for further instructions.
●
Keep all pets away from the spa to avoid any damage.
●
Do not add bath oil or bath salt to the spa water.
●
Avoid putting your head under the water at all times.
●
Avoid swallowing the spa water.
●
The spa contains a UVC emitter. To replace or repair the UVC emitter, contact a professional
operator.It's strictly forbidden for users to replace the UVC emitter. Unintended use of the
appliance or damage to the housing may result in the escape of dangerous UVC radiation.
UVC radiation, even in small doses, may cause harm to the eyes and skin.
WARNING: Do not operate the UVC emitter when it is removed from the appliance
●
enclosure or when the appliance is obviously damaged.
●
Consult experts or local authorities to apply local or national laws/regulations relating to
childproof fencing, safety barriers, lighting, and other safety requirements.
●
Always add chemicals to water, never add water to chemicals. Adding water to chemicals
may cause strong fumes or violent reactions and hazardous chemical spray.
●
For water that has already been used, dispose of it promptly or use water chemicals for cleaning.
Usually, it is recommended to drain and refill a spa with clean water every 3-5 days.
●
●
Use the chemical kit for disinfection in accordance with manufacturer's instructions.
●
Do not leave or set up the spa with a temperature lower than 4°C (39°F) if the heater is not
operating.
Always enter and exit the spa or hot tub slowly and cautiously. Take extra care if the floor is wet.
●
●
To avoid damage to the pump, never turn on the spa or hot tub if it is not filled to the mini-
mum water line.
●
The spa or hot tub must only be placed on a properly prepared site that meets the floor
loading requirement.
●
Do not leave the spa empty for an extended period of time. Drain the spa completely if it is
not going to be used for a long period of time. Do not expose the spa to direct sunlight.
●
Check regularly before each use. When the spa is not in use, store it away immediately or
keep it in an enclosed area.
Open the spa top lid when the Bubble function is on.
●
●
In order to avoid a hazard due to the inadvertent resetting of the thermal cut-out, this appli-
ance must not be supplied through an external switching device, such as a timer, or connect-
ed to a circuit that is regularly switched on and off by the utility.
●
Once the spa is installed, refer to the relevant chapters for details concerning cleaning, peri-
odic checks and other maintenance.
!
CAUTION
5
Publicidad
