Mounting The Table Saw; Adjustments; Adjusting Blade Parallel To The; Miter Gauge Slots - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 20

▼ MOUNTING THE TABlE SAW

If table saw is to be used in a permanent lo-
cation, it should be fastened securely to a
firm supporting surface such as a stand or
workbench, using the four mounting holes 24
(Fig. 19).
1. If mounting to a workbench, the base
should be bolted securely using 5/16"
hex bolts (not included) through mount-
ing holes 24.
Hint: If workbench is 3/4" thick, bolts
will have to be at least 3-1/2" long - if
workbench is 1-1/2" thick, bolts should
be at least 4-1/2" long.
2. Locate and mark where the saw is to be
mounted, relative to holes in the base of
the tool.
3. Drill four (4) 3/8" diameter holes
through workbench.
4. Place table saw on workbench aligning
holes in base with holes drilled in work-
bench.

▶ Adjusting Blade parallel to the

Miter Gauge Slots

The blade was adjusted parallel to the miter
gauge slots at the factory. In order to ensure
accurate cuts and help prevent kickback, this
adjustment should be rechecked. If adjust-
ment is necessary, follow the steps below.
the plug from power source before mak ing
any adjustments.
1. Turn elevation wheel and raise blade as
high as it will go.
2. Select a point on the body of the saw
blade that is set to the left when viewing
blade from the front of saw, and mark 1
with a pencil (Fig. 20).
3. Place the base of a combination square
against the edge of the miter gauge slot,
and extend the sliding rule of square so
it just touches the marked point 1 on
the body of the saw blade at the rear of
the table.
20
Storage, Transportation, and Mounting

Adjustments

To prevent personal in-
jury, always dis con nect
Fig. 19
5/16" HEX BOLT,
WASHER AND
5. Insert four (4) 5/16" dia. bolts through
holes in base and supporting surface;
then secure with (4) 5/16" flat washers
and (4) 5/16" hex nuts.
Fig. 20
Fig. 21
24
HEX NUT
X4
1
UNDER FRONT OF
TABLE
2