Getting To Know Your Table Saw - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 11
1. pOWER SWITCH
Switch incorporates hole for use with padlock to
prevent accidental starting.
2. TABlE
Provides large working surface to support work-
piece.
3. BASE / SUB-BASE
Supports table saw. Sub-base provides addi-
tional stability and ability for easy sliding onto
surfaces. Holes are pro vided in base to bolt the
saw to a workbench or stand.
4. BlADE BEVEl lOCK HANDlE
Locks the blade to de sired bevel angle.
5. TABlE EXTENSION
Provides a larger work surface for wider work-
pieces.
6. TABlE EXTENSION lOCK HANDlE
Allows you to lock the table extension at desired
distances.
7. ElEVATION WHEEl
Elevates or lowers the blade. Also used to tilt the
blade 0 to 45 degrees.
Fig. 1
2
13

Getting To Know Your Table Saw

19
21
10
7
4
1
8. BlADE BEVEl SCAlE
Shows the degree the blade is tilted.
9. RIp FENCE SCAlE
Shows the distance from the blade to rip fence
through a convenient viewing and magnifying
window. Lower portion of scale can be used up
to 13.5 inches. Upper portion of scale is used for
cuts beyond 13.5 inches.
10. MITER GAUGE
Head can be locked in desired position for cross-
cutting or mitering by tightening the lock knob.
ALWAYS SECURELY LOCK IT WHEN IN USE.
11. RIp FENCE STORAGE
Conveniently stores rip fence when not in use.
12. pRE-CUT (KERF) INDICATOR
Allows you to mark and locate exactly where the
blade will enter the workpiece.
13. MITER GAUGE STORAGE
Conveniently stores miter gauge when not in use.
14. BlADE STORAGE AND WRENCH
Allows you to store 10" blades and arbor wrench.
18
12
5 9
3
6
8
11