Changing The Blade; Attaching Rip Fence; Storage, Transportation, And Mounting; Miter Gauge Storage - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 18

▼ CHANGING THE BlADE

1. Turn elevation wheel clockwise until the
blade is up as high as it will go, remove
table insert 1 using finger hole (Fig. 11).
2. Lift up arbor lock lever 2 and slowly rotate
blade by hand until lock fully engages saw
arbor and stops rotation (Fig. 11). Loosen
arbor nut 3 counter clockwise with the
arbor wrench 4 provided (Fig. 12). Set
wrench aside and continue to loosen arbor
nut 3 by hand and re move arbor nut 3 and
outer washer 5. Blade may now be re-
moved or installed by sliding on or off
arbor shaft 6.
3. Assemble inner washer 7 and new blade
as shown in figure 13, making certain the
TEETH OF THE BLADE ARE POINTING
DOWN AT THE FRONT OF THE TABLE.
NOTE: The printing on different saw blades
are not always on the same side.
4. Assemble outer washer 5, arbor nut 3 as
shown in figure 13. While lifting up arbor
lock lever 2 securely tighten arbor nut 3
clockwise with the wrench 4 (Fig. 12).
5. Position table insert in pocket of table so
tabs 8 on table insert 1 are in slots in
pocket of table and push down and secure
in place.

▶ Attaching Rip Fence

A. Raise rip fence handle 1, so holding clamp
2 is out far enough to fit on the table 3 and
into "V" groove located on the back of rear
rail (Fig. 14).

▼ MITER GAUGE STORAGE

When not in use, store miter gauge 10 in
miter gauge storage slot 13 on the left side
panel of the saw (Fig. 15).
18
Assembly

Storage, Transportation, and Mounting

B. Position the rip fence 4 over table 3 hold-
ing up the front end, first engage holding
clamp 2 with rear rail.
C. Lower front end onto front rail 5.
Fig. 13
6
7
Fig. 14
4
B
2
3
Fig. 15
13
10
3
5
A
1
C
5