Assembly; Attaching The Smart Guard System; Positioning The Riving Knife - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 15
▶ Attaching the Smart Guard
System
from power source before attaching or re-
moving the Smart Guard System.

▼ pOSITIONING THE RIVING KNIFE

table saw. A loose riving knife may slip into
blade and be thrown towards you.
1. Remove table insert using finger hole.
2. Raise the blade as high as it will go and set
it perpendicular to table (0° on bevel
scale) (Fig. 5).
3. Rotate the riving knife release lever 1
clockwise, so that it points upward (Fig.
5).
4. Pull riving knife 2 towards release lever to
disengage it from the pins 3 (Fig. 6).
5. Slide the riving knife 2 up to its highest po-
sition, so that it is directly over the center
of the blade (Fig. 6).
6. Align holes in riving knife with pins 3 and
ensure pins engage riving knife holes. Lock
the riving knife release lever 1 by rotating
it counterclockwise. Firmly push lock lever
to secure riving knife then push/pull riving
knife to verify that it is locked in place (Fig.
6).
7. Check alignment of the riving knife with
the blade before replacing table insert and
attaching the guard assembly (refer to
"Riving Knife Alignment" section on page
22). If not aligned with the blade, then re-

Assembly

To prevent personal injury,
always dis con nect plug
Fully secure the riving
knife before using the
4
5
peat the process of positioning the riving
knife and be sure that the pins are fully en-
gaged in the riving knife holes.
8. Replace table insert (Fig. 7).
Fig. 7
2
Fig. 5
2
1
Fig. 6
2
3
1
7
6
15