Table Pointer Adjustment; Riving Knife Alignment; Checking Riving Knife Alignment - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 23

▶ Table pointer Adjustment

If an adjustment to the table pointer is nec-
essary, loosen pointer ad justment screw 1,
adjust pointer 2 and tighten screw 1
(Fig. 26).
The table pointer should always be adjusted
relative to fence pointer.
1. Adjust fence pointer to (zero) - see "Rip
Fence Pointer Adjustment".
2. Slide fence to the right until it hits the stop
plate on front rail and lock fence in place.
3. Look at fence pointer and note measure-
ment on lower scale (at or near 13.5").
4. Adjust the table pointer 2 to the same
reading on upper scale as that shown on
the fence pointer. Both pointers must
agree when fence is at this position.
Example: If fence pointer is at 13-9/16", then
table pointer should also be set at 13-9/16".

▶ Riving Knife Alignment

IMpORTANT: The Riving Knife 1 must always
be in line with the Saw Blade 2. The Riving
Knife 1 is thinner than the width of the Kerf 4
by approximately two thicknesses of standard
20 lb. (75gsm) copy paper 5 on each side (Fig
27). Note: The Kerf is the width of the cut
made by the teeth on the saw blade.
plug from power source before making any
adjustments and when attaching or remov-
ing the Smart Guard System.

▼ CHECKING RIVING KNIFE AlIGNMENT

NOTE: The Riving Knife has been properly
aligned at the factory - Check the alignment
before making any adjustments.
1. Raise the Saw Blade to maximum height
and set the bevel angle to 0°.
2. Remove the Barrier Guard Assembly and
Anti-Kickback Device.
3. Place the Rip Fence 3 on the right side and
slide it until it touches the tips of the Saw
Blade 2 - Lock fence.
4. Check the alignment:
A. From the top, look down over the Fence
and check that the Riving Knife is in line
(front to back) with the blade and par-
allel with the fence.
B. Slide the fence away from the blade.
Look over the front of the blade and
Adjustments
To prevent personal in-
jury, always disconnect
Fig. 26
1 2
1
5
5
WORK
4
2
LOOKING DOWN ON SAW
Fig. 28
5
1
8
7
6
8
2
check that the Riving Knife is in line with
the blade.
C. If steps A or B show misalignment, pro-
ceed to "Adjusting Riving Knife".
Fig. 27
5
3
23