Attaching The Guard Assembly; Attaching The Anti-Kickback Device - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 16
4

▼ ATTACHING THE GUARD ASSEMBlY

9. With one hand, hold the front of the bar-
rier guard assembly 4 by the "fork". With
the other hand, hold the guard release
lever 5 up (Fig. 7).
10. Lower the rear of guard assembly and slip
the cross bar 6 into the rear notch 7 on top
of the riving knife 2 (Fig. 7).
11. Lower the front of the guard assembly 4
until the "fork" is parallel with the table
(Fig. 8).
12. Press down on the guard release lever 5
until you feel and hear it snap into the lock-
ing position. Check that the guard assem-
bly is securely connected (Fig. 8).
Fig. 9
16
Assembly
Fig. 8
5

▼ ATTACHING THE ANTI-KICKBACK DEVICE

13. Attach the Anti-Kickback Device 7 into the
flat recessed area 8 of the riving knife 2
(Fig. 9).
14. Squeeze the compression pads 9 while
nesting the device into the flat area
(Fig. 9).
15. Release the compression pads such that
the Anti-Kickback Device locks onto the riv-
ing knife immediately behind the guard as-
sembly. Check that the attachment pin is
securely connected into locking hole.
Carefully raise and lower the pawls 10 –
when letting go, the spring-loaded pawls
must come down and contact the table in-
sert (Fig. 9).
7
9
8
2
9
10