Basic Table Saw Operation; Power Switch; Using The Smart Guard System; Riving Knife / Splitter - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 26
▶

power Switch

To turn saw on: lift switch lever by pinching
side walls and pulling up. This action starts
the saw (Fig. 34)

Fig. 34

▶ Using the Smart Guard System

The Bosch Smart Guard has been designed
for modularity, enabling the use of multiple
combinations of the three main components
– 1 Riving Knife / Splitter, 2 Main Barrier
Guard, and 3 Anti-kickback Device (Fig. 36).
Additionally, the riving knife can be quickly
adjusted to three positions depending on the
application requirement: through cut (high),
non-through cut (middle), and dado (lowest).
The three primary components of the Smart
Guard blade guarding system are designed
for rapid attachment, adjustment, and/or re-
moval without the need for additional tools.
Any Smart Guard components that need to
be removed to complete a cut should be im-
mediately reinstalled when finished. See
pages 15–16 for detailed installation instruc-
tions. Always remember that the best acci-
dent prevention is the operator's use of
Fig. 37
A
26

Basic Table Saw Operation

Fig. 35
ON

▼ RIVING KNIFE / SplITTER

B
To turn off power: push switch lever down to
its original position (Fig. 35).
To prevent unauthorized use, the switch can
accommodate a padlock with a long, 3/16" or
1/4" diameter shackle (not provided with
table saw), (Fig. 35).
2
3
1
common sense and alertness at all times
when using the table saw.
The Riving Knife (splitter) is the central ele-
ment of the Bosch Smart Guard blade guard-
ing system, serving as the attachment point
OFF
Fig. 36
C