Installing A Dado Set; Using Stacked Dado Sets; Jury, Always Disconnect; Raise The Saw Blade To Maximum Height - Bosch 4100 Instrucciones De Funcionamiento

2610048783.qxp_4100 11/17/17 9:10 AM Page 39
booklet furnished with these accessories.
ALWAYS USE AN APPROPRIATE BOSCH
TABLE INSERT AND WASHERS LISTED
UNDER RECOMMENDED ACCESSORIES (see
page 44).
ALWAYS PLACE THE BLADE WASHERS IN THE
ORIGINAL POSITIONS WHEN YOU ARE FIN-
ISHED DADO OR MOLDING CUTTING.

▼ INSTAllING A DADO SET

A dado set is an accessory system used to
make non-thru grooves or lap cuts on work
pieces. These tools are commonly used in fur-
niture and cabinet building. After work pieces
have been properly dado cut, they can be
tightly joined together. The 4100 table saw
can accommodate dado cutting up to 13/16"
wide in a single pass.
plug from power source before changing
blades.
Bosch Dado Blade Table Insert No.TS1007
(comes with a dado accessory washer).
Never make dado cuts without this insert. Do
not use dado sets larger than 8" diameter.
Never set dado cutters to any bevel angle
other than the vertical 0° angle. Follow all
warnings and instructions shown here and
those that accompany your dado set. Failure
to comply with these warnings may result in
serious bodily injuries.
larger than 8 inches in diameter. The saw is
not designed to accept larger sized dados.
Fig. 62
OUTER BLADE
WASHER
ARBOR
INNER BLADE
Basic Table Saw Operation
To reduce the risk of in-

jury, always disconnect

To reduce the risk of in-
jury, always use the
To reduce the risk of in-
jury, do not use dado sets
CHIPPERS

▼ USING STACKED DADO SETS

To reduce the risk of in-
jury or property damage,
read and follow all Operation/Safety In-
structions included with the dado set before
use.
NOTE: These instructions apply when using
most standard stacked dado sets. Do not use
dado set if manufacturer instructions differ
from the ones provided below.
1. Disconnect plug from power source.
2. Remove the Barrier Guard Assembly
and Anti-Kickback Device (see page 15
and 16). Lower and lock the Riving Knife
in its lowest position.
3. Remove standard table insert plate.
Raise saw blade to maximum height.
4. Remove the arbor nut, then outer
washer, saw blade, and inner blade
washer (see page 17). Note: For only
dado cutting, the washers must be in-
stalled differently (Fig. 63).
5. Installing a dado stack (Fig. 62)
A. Place the (flat) outer washer back
onto the arbor shaft. For dado cut-
ting, this will serve as the inner
washer.
B. Place the desired parts of the dado
set onto the arbor shaft.
C. Place the supplied washer from the
Dado Accessory Kit (TS1007) onto
the outside of the dado stack.
D. Replace and tighten the arbor nut
onto the arbor shaft (Fig. 63).
INNER BLADE WASHER
(1/2" OR LESS)
OUTER BLADE
ARBOR NUT
ACCESSORY DADO
WASHER
(1/2" TO 13/16" MAX.)
39