Optos Daytona P200T Guia Del Usuario página 29

3 How to...
Before using the system and capturing images, you should be familiar with all the features and capabilities of
the system.
3.1 Get started
CAUTION
You must start and shut down the device each working day.
Note
The device automatically logs out and the touch screen goes dark when the device is
touch screen activates the touch screen and lets you log in.
3.1.1 Switch on each day
The image server and scan head must be switched
3.1.1.1 Switch on the image server
The review, admin and storage services run on the image server. You do
as the server only needs to be switched on.
1. Check that the power supply is switched on.
2. Switch on the image server.
Note
If it seems the image server is not working, check the monitor is switched on then confirm the image server is
switched on.
3.1.1.2 Switch on the scan head
CAUTION
You must start and shut down the scan head each working day.
1. Remove the scan head fabric cover.
2. Check the image server is switched
3. Switch
Part Number: G102748/9GCA
Copyright 2017, Optos plc. All rights reserved.
Read the warnings and cautions before using your device.
If applicable, also read the country-specific warnings and cautions, see Country-specific
warnings and cautions on page 20.
Only use the fabric cover when the scan head is powered
before operating the scan head.
the scan head.
ON
If the scan head has been shut down the status indicator will be
l
on the back of the scan head to the
each day for the device to operate.
ON
and fully started up before switching
ON
( ) position. There will be a short delay while the
ON
Chapter 3 - How to...
in use. Using the
NOT
need to login to the image server
NOT
. Remove the fabric cover
OFF
the scan head.
ON
OFF . Press the power switch
Page 29 of 65
English