Fresenius Kabi COM Instrucciones De Uso página 14

8 Technical information
8.1 Operation mode
The holder is a reusable device and the mode of operation is continuous.
8.2 Power supply specifications
The power cable must be connected directly to the mains power socket.
Protection against electric shocks: class II
Holder input
Holder output
Power cable length
8.3 Nurse Call Specifications
Nurse Call Connector Specifications:
Input/output
Electrical insulation
The following table lists the minimum requirements that the connected Nurse Call
system must fulfil:
Nurse Call system specification
System type
Compatibility
Maximum power
Electrical insulation
Compliance with standards
8.4 RS232 serial communication connector specifications
Input/output
Electrical insulation
Compliance with standards
CAUTION
▪ This connector is for data communication and maintenance use only.
Improper use of the RS232 Serial communication connector may
cause the impossibility to perform maintenance or data
communication.
14
AC input voltage: 100-240 Vac
AC input frequency: 50/60 Hz
AC input current: 110mA-205mA
9 Vdc ± 5 % / 9W (maximum load)
Approx. 2 m (except plug type M is approx. 3 m)
24 Vdc SELV(Safety Extra Low Voltage)/ 0.5 A maximum
24 Vac / 0.5 A maximum
1.5 kV insulation
Electrical analogical system.
Compatible with 3 wires contacts. Relay
type, dry contacts stand-off / work contact
– positive / negative polarity option.
DC 24V – 0.5 A maximum or
AC 24V – 0.5 A maximum.
1.5 kV insulation.
IEC/EN 60601-1 (leakage current).
RS232 signal
1.5 kV insulation
IEC/EN 60601-1 (leakage current)
24 Vac / 0.5 A maximum
Minimum requirement