Publicidad
Idiomas disponibles
Idiomas disponibles
After-sales services
If you encounter problems during usual operation, please contact one of the Franke authorised
service providers listed in the annex.
Never consult unauthorised service providers.
Installation
Installation works for both gas and electricity are explained in the following sections. These
works must be performed by qualified persons as per the applicable law. Works performed by
inexperienced persons might pose risk. The manufacturer or the seller shall not accept any
responsibility for personal injuries or material damages resulting from failure to observe these
instructions. For the gas installation, the rules/laws in the country in which the appliance will
be installed are observed. Therefore, before placing the product, please make sure that the
local distribution conditions (gas type and gas pressure) and product settings are suitable.
Setting conditions of this product are indicated on the label.
Preparing the furniture
This manual is intended for a Class 3 built-in hob. Prepare the installation area with the
dimensions shown in Figures 2 and 3. Please adjust the best possible location to easily open
the product in case of any possible problems. Make sure that the gas pipe of the hob do not
contact the edges.
Installing the product onto the furniture
After making the connections, surround the edges of the hob (as a strip) with the epdm foam
provided together with the installation parts and lean it. Slightly tighten the fixing hook and
use a curved knife to eliminate excess epdm foam.
Gloves must be worn to avoid accidents during installation.
Installation information of the appliance
Warning:
This appliance must be installed in well-ventilated areas in accordance with the
applicable legislation. Please read the instructions before installing or using the
product.
Warning:
This product is not connected to a system for discharging combustion products.
This product must be connected and installed in accordance with the applicable
installation norms. Special attention must be paid for requirements regarding
ventilation.
The person installing the appliance must observe rules and norms regarding ventilation and
discharge of exhaust gases.
9
Publicidad
