Amprobe WT-30 Manual De Uso página 17

"E03" Salt value is over the range limit (70.0ppt) or
meter is damaged.
• Put the meter in standard solution. If E03
still appears, send back for repair.
"E04" Caused by temp. error
• Refer to error code of temperature. After
solving the error of temp., E04 will disappear.
Parameter: Temperature
"E01" Temperature circuit is damaged
• Send back for repair
"E02" Temp value is lower than range limit (0°C) or
temp. circuit is damaged
• Put the meter in room temp. for 5 mins. If
E02 still appears, send back for repair.
"E03" Temp value is higher than range limit (50°C)
or temperature circuit is damaged
• Put the meter in room temp. for 5 mins. If
E02 still appears, send back for repair
Figer 1. Figer 2.
11
Figer 3.