Tabla de contenido
Publicidad
Automatic Buttonhole (Continued)
e TO Sew
O Stitch selector:
2
(_ Stitch width:
2
® Stitch length:
3 to 4
® Needle thread tension:
2 to 6
® Presser foot:
Buttonhole foot
NOTE; Best results are obtained by using #60 or #80
lightweight thread for bobbin thread.
It is advisable to use a #'11 blue stretch needle
when sewing Imits and synthetic fabrics,
You can obtain buttonholes
with wider cutting
space by setting stitch width at 1 _5 instead of 2.
® Needle thread (Top thread)
(_) Bobbin thread (Bottom thread)
® Two round holes
® Rectangular hole
® Two pins fitting with the two round holes
® Lever
(_) Hook fitting with the rectangular hole
® Base plate
Remove the extension
table (accessory
box)
Raise the
needle to its highest position by turning the handwheet coun-
terclockwise. Remove the foot holder. Pull bobbin thread
about 3" (7.0 cm) straight back toward the rear of the ma-
chine. Insert the hook of the base plate (_) into the rectangu-
lar hole on the needle plate (_). Pull lever ® back to align the
hook with the rectangular hole. Snap base plate ® down to
fit the two pins (_ at the back of base plate into the two round
holes on needle plate (_) Release the lever.
©
_
WIDTH
(_
_
LENGTH
(_
®
®
82
Publicidad
Tabla de contenido
