Festool KS 60 E Manual De Instrucciones página 27

WARNING
The pendulum guard does not close
Risk of injury
► Stop the sawing process.
► Unplug the mains cable and remove waste.
In the event of damage, remove the pendu-
lum guard.
Working safely
When working on the machine, observe
all of the safety notes that are listed at
the start and the following rules:
–
Correct working position:
– At the front on the side of the operator;
– Head-on to the saw;
– Beside the line of cut.
–
During operation, always hold the power
tool tightly by the handle [1-1] in your op-
erating hand. Always keep your free hand
outside of the hazardous area.
–
Only guide the power tool towards the
workpiece when it is switched on.
–
Adjust the feed speed in order to prevent
the machine from overloading and to pre-
vent the plastic from melting if you are cut-
ting plastics.
–
Ensure that the star handle [2-9] and the
rotary knob [2-6] have been tightened.
–
Do not work on the power tool if its elec-
tronics are defective as this may lead to ex-
cessive speeds. You can tell if the electron-
ics are defective if there is no smooth start-
up, if it is not possible to regulate the speed
and in the event of generation of smoke or
the smell of burning from the machine.
8.1 Clamping the workpiece
Warning! Note the workpiece's proper-
ties:
Risk of injury
Securely in place – Place the workpieces on the
stop ruler. Do not process any workpieces that
have not been securely clamped.
Size – do not process workpieces that are too
small. In the interests of safety, the cut piece
remaining should be at least 30 mm long.
Small workpieces may be pulled backwards by
the saw blade and into the gap between the saw
blade and the stop ruler.
Correct support – Observe the maximum work-
piece dimensions. Always use and secure ex-
tensions to the workpiece support. Otherwise,
the workpiece may be subjected to internal
stresses, which may lead to sudden deforma-
tions. If required, observe the information for
workpiece dimensions (see section ) 7.4.
Proceed as follows to clamp the workpiece [7]
► Push the saw unit downwards until it rea-
ches the limit stop.
►
Pull the lever for the transport locking de-
vice [7-1].
►
Slowly guide the saw unit upwards.
►
Place the workpiece so that it is flush with
the stop ruler [7-3].
►
Use the fastening clamp [7-2] to secure the
workpiece in place.
►
Check that the workpiece is securely in
place.
Observe the workpiece dimensions
8.2
Maximum workpiece dimensions without
extension using accessory parts
Mitre/bevel angle, to Height x width x length
scale
0°/0°
45°/0°
0°/45° right
0°/45° left
45°/45° right
45°/45° left
Maximum workpiece dimensions when
installing together with UG-KS60 and KA-KS60
The maximum height and width of the work-
piece do not change if accessory parts are in-
stalled. The contact surface when installing the
English
60 x 305 x 720 mm
60 x 215 x 720 mm
20 x 305 x 720 mm
40 x 305 x 720 mm
20 x 215 x 720 mm
40 x 215 x 720 mm
27