SURE petcare Microchip Pet Door Manual De Uso página 18

7.6 Fixing the SureFlap Microchip Pet Door from the inside of the home
For most installations screwing the unit from the inside is not necessary. For those
particularly concerned about security there is the option to go to the additional effort of fixing
the unit to the door from the inside during the installation process by following the steps
below.
For door installations -
1. Install the pet door as per the instructions in section 7.2.
2. Remove the front panel of the unit as described in step 13 of the wall installation
instructions.
3. Using a small drill bit drill part way into the door (as shown in figure 29) through the four
holes below the normal installation screw holes (shown in Figure 30).
4. Screw the unit into the door from the inside using the appropriate length of screw. See
figure 31.
5. Replace the front panel of the pet door and screw it back into place.
6. Replace the screw caps and button cover.
For glass installations -
1. Install the pet door as per the instructions in section 7.3.
2. Remove the front panel of the unit as described in step 13 of the wall installation
instructions.
3. Screw the unit into the external frame and mounting adaptor from inside the house using
the second set of screw holes as shown in figure 30. Please ensure you use the correct
length of screw to ensure they do not protrude from the unit.
4. Replace the front panel of the pet door and screw it back into place.
5. Replace the screw caps and button cover.
DOOR
INSIDE OUTSIDE
Figure 29 Figure 30
17
Figure 31