Curfew Mode - SURE petcare Microchip Pet Door Manual De Uso

11. Curfew Mode

Curfew mode allows you to set a lock and unlock time for the SureFlap Microchip Pet Door,
giving your pet access to the outdoors during a set period of the day (for example unlocking
in the morning and locking at night). In order to set the times follow the steps below. At the
selected lock time the pet door will be set to "in only", meaning the cat is still able to enter
the house after the lock time but can not leave again.
1. Set the current time - In order to use curfew mode you must first set the current time. To
do this press and hold the current time button ( ), see figure 36) for around 3 seconds and
the time on the LCD screen will flash. To change the time press ( ) repeatedly or press
and hold for faster increments. Once you reach the correct time release the button for a
couple of seconds and the unit will store the time and stop flashing.
2. Set the lock time - Repeat the process of setting the time as above, this time pressing
the lock time button ( ), see figure 37).
3. Set the unlock time - This is set using the unlock time button ( ), see figure 38).
Figure 36 Figure 37 Figure 38
4. Activate curfew mode - To activate curfew mode press the locking mode button (
)
until the current time is displayed on the LCD screen (as shown in figure 39).
To subsequently deactivate curfew mode, press the locking time button ( ) once and
the current time should disappear from the LCD screen.
Figure 39
You can view the lock/unlock times that have been set on the LCD screen by pressing the
relevant timer button once. You only need to set the time once (unless of course it requires
changing e.g. daylight saving time), the pet door will remember the time whether you are
using curfew mode or not. However the pet door will not remember the time if the batteries
are changed or run out, in this case you will need to reset the time.
If in the rare instance you need to keep your pets out at certain times (e.g. to prevent them
from bringing prey into the house at night) you can select custom mode 6 (see section 14).
20